Prx Build Limitless Half Rack - Manual

Download PDF

Build Limitless® Half Rack

Tool List

• 15/16” Box End Wrench

• 15/16” Socket

• Ratchet or Impact Driver

Item # Description Qty.

1 Upright 4

2 Multi-Grip Pull-Up Bar 1

3 Short Crossmember 4

4 Long Crossmember 1

5 5/8” Nylock Nut 28

6 5/8” Flat Washer 26

7 5/8” x 4-1/4” Hex Bolt 18

8 L - Foot or Angled Foot 2

9 5/8” x 4-1/2” Hex Bolt 8

10 J-Cup Pair 1

11 PRx Logo Plate 1

12 Logo Plate Backer 1

13 Floor Spreader Plate 1

14 5/8” x 4” Hex Bolt 2

WARNING

• Read all assembly, installation and use instructions in this manual prior to using this equipment.

• Inspect equipment prior to use. DO NOT use if it appears damaged or inoperable

• Use equipment only for the intended use DO NOT modify the machine

• DO NOT attempt to fix broken equipment. Call or email PRx Performance for assistance.

• SQUAT RACK MUST BE BOLTED TO THE GROUND

Save this manual for future reference.

060325_Rev. 1

2

Rack Assembly (Rear):

1. Attach Short Crossmembers (3) and Long Crossmember (4) to the top of the rear Uprights (1)

with the hardware shown. Figure 1, Detail A

NOTE 1: Numbers and PRx logo at the top of the uprights are shown facing the rear of the rack.

Customers can choose to rotate the uprights 180 degrees, so the logo and numbers are facing

the front. Figure 1, Detail A

NOTE 2: Short Crossmembers at the top of the Uprights should be oriented with the long leg of

the end plates facing upward and the short leg facing down. This will be the opposite for the

Long Crossmember (4) across the top/rear of the rack. This is to account for the offset holes in

the uprights and keep the tubes of the crossmembers at the same height. Figure 1, Detail A

2. Attach Short Crossmembers (2) to the front/bottom of the Uprights (1) with hardware shown.

NOTE: The Bottom Crossmembers are oriented opposite the top, with the long leg of the end

plates facing downward and the short leg facing upward. Figure 1, Detail B

3. Attach the Floor Spreader Plate (13) between the bottoms of the Uprights (1) with hardware

shown. Figure 1, Detail B

3

Rack Assembly (Rear):

Figure 1

4

Rack Assembly (Front):

1. Attach the front Uprights (1) to the front of the Short Crossmembers (3) with hardware shown.

Figure 2 Details, C & D

2. Attach either the L-Feet or Angled Feet (8) to the front of the uprights with hardware shown.

NOTE: L-Feet as shown in Figure 2 are to be used if purchased as a Functional Trainer. Angled

Feet as shown in Figure 3 to be used if purchased only as a Half Rack.

3. Attach the Multi-Grip Pull-Up Bar (2) between the top of the front Uprights (1) with hardware

shown. Figure 2, Detail C

4. All hardware can be fully tightened.

WARNING: Do not overtighten as it will cause the uprights tube to deform.

Figure 2

5

Rack Assembly (Front):

Figure 3

6

Attach Logo Plate and J-Cups:

1. Attach PRx Logo Plate (11) and Backer Plate (12) with hardware shown. Figure 4, Detail F

2. Attach J-Cups (10) onto your uprights.

Figure 4