Prx Build Limitless Squat Stand - Manual

Download PDF

Build Limitless® Squat Stand

Tool List

• 15/16” Box End Wrench

• 15/16” Socket

• Ratchet or Impact Driver

Item # Description Qty.

1 Upright 2

2 Multi-Grip Pull-Up Bar 1

3 5/8” Nylock Nut 10

4 5/8” Flat Washer 8

5 5/8” x 4-1/2” Hex Bolt 8

6 Angled Foot 4

7 Floor Spreader Plate 1

8 5/8” x 4-1/4” Hex Bolt 2

9 J-Cup Pair 1

WARNING

• Read all assembly, installation and use instructions in this manual prior to using this equipment.

• Inspect equipment prior to use. DO NOT use if it appears damaged or inoperable

• Use equipment only for the intended use DO NOT modify the machine

• DO NOT attempt to fix broken equipment. Call or email PRx Performance for assistance.

• SQUAT RACK MUST BE BOLTED TO THE GROUND

Save this manual for future reference.

042525_Rev. 1

2

Rack Assembly:

1. Attach Angled Feet (6) to the bottom of the Uprights (1) with the hardware shown. Figure 1,

Detail B

NOTE 1: Make sure numbers and PRx Logo are facing the front of the rack.

NOTE: Leave all hardware somewhat loose until the rack is completely assembled.

2. Attach Multi-Grip Pull-Up Bar (2) between the top of the Uprights (1) with hardware shown.

Figure 1, Detail A

3. Attach the Floor Spreader Plate (7) between the bottoms of the Uprights (1) with hardware

shown. Figure 1, Detail C

4. Once all parts are assembled, stand rack upright and start tightening hardware from the ground

up.

Figure 1

050525_Rev. 2